BendPak XPR-10S-LP


SKU: 5175396 Category: Tags: , , ,


The safe and rugged XPR-10S-LP two-post lift, CE approved and certified, features our exclusive Low-Pro™ arms that accommodate lowered sports cars and those vehicles with exclusive lift points located on the extreme outer edges of the chassis. A telescoping overhead structure provides the convenience of wide or narrow installation wrapped up into one configurable package. This unique configurable design allows you to choose the best setting for your specific space or vehicle lifting requirements. The highly sophisticated yet simple and dependable XPR-Series design requires very little service or maintenance for an overall lower cost of ownership.

All BendPak's XPR two-post models feature dual "direct-drive" low-pressure cylinders, maintenance-free UHMW load bearings, single-piece columns, extra-tall lifting carriages and double telescoping arm configuration for increase arm positioning versatility.

The XPR-10S-LP features double-telescoping screw pads with gouge and tear-resistant polyurethane pads to help increase workplace safety and reduce operating costs. A set of our 63 mm stacking adapters included as standard accessories.

  • 10,000-lb lifting capacity
  • CE Approved and Certified. Meets or exceeds the standards prescribed by European Standard EN 1493
  • Telescoping Low-Pro™ arms accommodate lowered sports cars and those vehicles with lift points located on outer edges of the chassis
  • Expandable top beam accommodates wide or narrow configuration
  • Padded overhead safety shut-off bar
  • Single-piece columns
  • Dual hydraulic direct-drive cylinders
  • Over-sized 53" tall carriage for superior strength and durability
  • Electric / hydraulic power system
  • Large, 17" x 19" A36 steel base plate
  • Self-lubricating dura-glide UHMW polyethylene bearing system
  • Single-point safety release
  • Safety locks in each column spaced every 3"
  • Automatic arm restraints
  • Heavy-duty 1/2" aircraft-quality equalizer cables
  • Over-sized cable sheave diameter reduces cable fatigue
  • 4-piece 63mm stackable adapter set standard
  • ALI certified
  • Meets or exceeds the standards prescribed by ANSI/ALI ALCTV-2011
  • Lifting capacity*: 10,000 lbs.
    • *Max capacity / front axle: 5,000 lbs.
    • *Max capacity / rear axle: 5,000 lbs.
  • Overall height: 145"
  • Overall width - NARROW CONFIG: 132"
  • Overall width - WIDE CONFIG: 145"
  • Width outside of columns (NARROW): 127"
  • Width outside of columns (WIDE): 140"
  • Floor to overhead switch*: 141"
  • Inside columns (NARROW): 105"
  • Inside columns (WIDE): 118"
  • Front arm min reach: 28-1/2"
  • Front arm max reach: 47-1/2"
  • Rear arm min reach: 28-1/2"
  • Rear arm max reach: 47-1/2"
  • Min pad height: 4-1/4" to 6-3/4"
  • Rise: 69"
  • Lift height max (pad only): 73" to 75"
  • Lift height max (with adapter): 75-1/2" to 77-1/2"
  • Motor: 220 VAC / 60 Hz / 1 Ph
  • Time to full rise: 45 sec
  • Max load per arm: 2,500 lbs.

XPR10 Series Manual

XPR-10S-LP Catalog Sheet

Additional information



There are no reviews yet.

Be the first to review “BendPak XPR-10S-LP”

Your email address will not be published. Required fields are marked *